Thread Rating:
  • 25 Vote(s) - 3.28 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Berlingo Fault Codes
#1
Hi Folks, In relation to OBD fault codes, does anyone know where I can get a list of the manufacturers specific fault codes for a Mk1 1.4 Berlingo Multispace as opposed to the generic ones that I already have. I don't have a problem (yet!) but would like to be ready.
Cheers,
Griff:wave:
Landmark
Ex 1.4 Berlingo Multispace
Reply
#2
Hi Landmark.
What engine? CNG, LPG, with one or two carbs?
If it's a inj engine, who made ecu? MM, Bosch, Sagem?
Please, provide us a type or model of ecu.
Reply
#3
(06-11-2011, 06:21 AM)pk7478 Wrote:  Hi Landmark.
What engine? CNG, LPG, with one or two carbs?
If it's a inj engine, who made ecu? MM, Bosch, Sagem?
Please, provide us a type or model of ecu.
Hi PK, It's a 2002 1.4 petrol with injetion. How do I find ecu make? Would a PM of the vin no. help?
Regards,
Griff
Landmark
Ex 1.4 Berlingo Multispace
Reply
#4
http://www.bba-reman.com/content.aspx?co...ault_codes

ive found this site in my searches dont know if its any good to you as im not that far down the line at the moment myself to check .

what reader you got landmark and do you recommend .


thanks
Reply
#5
Hi Wertyu2007,
Many thanks for that, it seems what needed.
I've just bought an Autel MaxiScan MS509 (about £80) to try and sort out a problem of overheating with our 2002 1.4 petrol Mk1 Multispace. The only error code it throws up is a generic "P0130 O2 Sensor Circuit Bank 1 Sensor 1"
It's been into several garages, who have replaced various sensors, but it still happens if you get stuck in traffic. I think it's the fans not cutting in but I'm never there to check if the're running when it happens.
Regards,
Griff
Landmark
Ex 1.4 Berlingo Multispace
Reply
#6
hi mate
thanks for reply on reader ill have look at that .

my sisters peugeot always throws up that code but runs fine could just be going over the lamda sensors limits known and again throwing up that code or just need a good service but not certain on that just a guess , id imagine that its a coincidence the overheating and the code .
http://www.permoveo.ltd.uk/tabid/122/OBD...fault.aspx

if i was you id just go through usual with overheating issues radiator , pump , fans , fan switches and relays etc.
my citroen relay van did the same overheated all te time it was the fan switch on eside of radiator when i finally got around to working on it.

good luck


barry

[-] The following 2 users say Thank You to wertyu2007 for this post:
  • Landmark, UpDownUnder
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)
[-]
Welcome
You have to register before you can post on our site.

Username:
  

Password:
  




[-]
Search
(Advanced Search)

[-]
Latest Threads
Slow starter (diesel)
Last Post: zedhead
Today 10:09 AM
» Replies: 10
» Views: 218
ABS Modul
Last Post: highlander
Today 09:17 AM
» Replies: 0
» Views: 24
Type B MFD & Trip Computer
Last Post: cancunia
Today 08:55 AM
» Replies: 2
» Views: 76
Aftermarket radio stalk CTSCT003.2 Problem v2
Last Post: brajomobil
Today 07:39 AM
» Replies: 3
» Views: 112
jumps out in third gear..
Last Post: polar
Today 05:22 AM
» Replies: 7
» Views: 115
Fuel Guage wrong
Last Post: polar
Today 05:21 AM
» Replies: 1
» Views: 45
Wont start after dashboard removel
Last Post: joelfrodin
Yesterday 05:53 PM
» Replies: 10
» Views: 398
cold start
Last Post: geoff
Yesterday 05:23 PM
» Replies: 2
» Views: 80
Hello !
Last Post: geoff
Yesterday 09:52 AM
» Replies: 2
» Views: 63
Strut replacement- Spring Compression
Last Post: ffrenchie
Yesterday 09:15 AM
» Replies: 11
» Views: 439

[-]
Recent Visitors
Locations of visitors to this page