Current time: 01-08-2014, 10:26 PM Hello There, Guest! (LoginRegister)
Home  |  Memberlist  |  Member Map  |  E-Garage  |  Search  |  Forum Help  |  Stickers  |  Donate


 
Thread Rating:
  • 18 Votes - 3.33 Average
  • 1
  • 2
  • 3
  • 4
  • 5
heater matrix
09-09-2011, 05:07 PM
Post: #1
heater matrix
just started changing heater matrix and ive been told you have to take out the dash,so ive started it .i unpluged the plugs to the dash clocks, and light and indicater stalks, now i have a flashing key symbol on the dash also a bleeping alarm, and the van wont start i think its turned off the diesel pump.anyone have any idea what ive done cheers!
Find all posts by this user
Add Thank You Quote this message in a reply
09-09-2011, 05:59 PM
Post: #2
RE: heater matrix
(09-09-2011 05:07 PM)dowdy Wrote:  just started changing heater matrix and ive been told you have to take out the dash,so ive started it .i unpluged the plugs to the dash clocks, and light and indicater stalks, now i have a flashing key symbol on the dash also a bleeping alarm, and the van wont start i think its turned off the diesel pump.anyone have any idea what ive done cheers!

Before you unplug anything you must disconnect the battery following this procedure
http://www.bba-reman.com/content.aspx?co...ot_process
Failure to do this can make the BSI throw a wobbly or even corrupt its software.

Once battery is disconnected before doing anything give the airbag system time to shut down fully.10 to 20 minutes I allow 30 minutes.
Best advice I can give you is disconnect the battery now,allow time period above for airbags.
Reconnect all the plugs you have unplugged.
Reconnect battery following BSI Reboot process.
Make sure everything works ok.
Then disconnect battery again using method in above link.
Allow time for airbag system to shut down.
You should now be ok to start unpluging connections to enable removal of dashboard

2003 Citroën Berlingo 2.0HDi Multispace Desire
Find all posts by this user
Add Thank You Quote this message in a reply
[+] 1 user says Thank You to BlueBlingo for this post
09-09-2011, 06:11 PM
Post: #3
RE: heater matrix
(09-09-2011 05:59 PM)BlueBlingo Wrote:  
(09-09-2011 05:07 PM)dowdy Wrote:  just started changing heater matrix and ive been told you have to take out the dash,so ive started it .i unpluged the plugs to the dash clocks, and light and indicater stalks, now i have a flashing key symbol on the dash also a bleeping alarm, and the van wont start i think its turned off the diesel pump.anyone have any idea what ive done cheers!

Before you unplug anything you must disconnect the battery following this procedure
http://www.bba-reman.com/content.aspx?co...ot_process
Failure to do this can make the BSI throw a wobbly or even corrupt its software.

Once battery is disconnected before doing anything give the airbag system time to shut down fully.10 to 20 minutes I allow 30 minutes.
Best advice I can give you is disconnect the battery now,allow time period above for airbags.
Reconnect all the plugs you have unplugged.
Reconnect battery following BSI Reboot process.
Make sure everything works ok.
Then disconnect battery again using method in above link.
Allow time for airbag system to shut down.
You should now be ok to start unpluging connections to enable removal of dashboard

i think ive already cocked up ,i unplugged everthing with battery attatched .i started to do it then thought i would use some k seal to see if i could seal the matrix instead of taking out dash, when i plugged everythink back in i had the flashing key and it wont start .everything works lights indicators all dash lights, heater plugs are working, its turning over ,but i dont think its getting fuel because its been locked out some how cheers dowdy
Find all posts by this user
Add Thank You Quote this message in a reply
09-09-2011, 06:26 PM
Post: #4
RE: heater matrix
Disconnect & reconnect battery following BSI reset procedure.

Has your vehicle got a fuel supply cut off switch if so check it as it might need resetting.
Let us know how you get on .

2003 Citroën Berlingo 2.0HDi Multispace Desire
Find all posts by this user
Add Thank You Quote this message in a reply
[+] 1 user says Thank You to BlueBlingo for this post
10-09-2011, 08:50 PM
Post: #5
RE: heater matrix
(09-09-2011 06:26 PM)BlueBlingo Wrote:  Disconnect & reconnect battery following BSI reset procedure.

Has your vehicle got a fuel supply cut off switch if so check it as it might need resetting.
Let us know how you get on .

where do i find it and do u know how to reset it/im putting dash back in tommorow matrix is back in and heater system bolted up,and system is full of water and the leak is sorted .it is quite a big job but now im feeling its worth doing it....
Find all posts by this user
Add Thank You Quote this message in a reply
11-09-2011, 09:48 AM
Post: #6
RE: heater matrix
(10-09-2011 08:50 PM)dowdy Wrote:  
(09-09-2011 06:26 PM)BlueBlingo Wrote:  Disconnect & reconnect battery following BSI reset procedure.

Has your vehicle got a fuel supply cut off switch if so check it as it might need resetting.
Let us know how you get on .

where do i find it and do u know how to reset it/im putting dash back in tommorow matrix is back in and heater system bolted up,and system is full of water and the leak is sorted .it is quite a big job but now im feeling its worth doing it....
Whoops just noticed your`s is a diesel so forget about fuel cut off switch ! Switch only on petrol engines RHS engine compartment

2003 Citroën Berlingo 2.0HDi Multispace Desire
Find all posts by this user
Add Thank You Quote this message in a reply
11-09-2011, 07:14 PM
Post: #7
RE: heater matrix
just got all the dash back in, clocks are in ,steering columb is back together.water in system no leaks,everthing wired up again battery on ,OH NO ! still got flashing key symbol on clocks and it wont start. But look on the bright side ive done the heater matrix which i wouldnt wish on anyone. so if anyone knows the answer dont hesitate cheers DOWDY...
Find all posts by this user
Add Thank You Quote this message in a reply
12-09-2011, 05:44 PM
Post: #8
RE: heater matrix
(11-09-2011 07:14 PM)dowdy Wrote:  just got all the dash back in, clocks are in ,steering columb is back together.water in system no leaks,everthing wired up again battery on ,OH NO ! still got flashing key symbol on clocks and it wont start. But look on the bright side ive done the heater matrix which i wouldnt wish on anyone. so if anyone knows the answer dont hesitate cheers DOWDY...

Can you provide some more vehicle details as follows:
Age.
1.9, 1.6 or 2.0 HDi,
VIN No ,
RPO No (On Sticker below RHS `A`Post might be something like 09804).
Man or Auto Transmision
ABS Yes or No
EPS Yes or No
Have you checked all the fuses ?

2003 Citroën Berlingo 2.0HDi Multispace Desire
Find all posts by this user
Add Thank You Quote this message in a reply
12-09-2011, 05:51 PM
Post: #9
RE: heater matrix
(12-09-2011 05:44 PM)BlueBlingo Wrote:  
(11-09-2011 07:14 PM)dowdy Wrote:  just got all the dash back in, clocks are in ,steering columb is back together.water in system no leaks,everthing wired up again battery on ,OH NO ! still got flashing key symbol on clocks and it wont start. But look on the bright side ive done the heater matrix which i wouldnt wish on anyone. so if anyone knows the answer dont hesitate cheers DOWDY...

Can you provide some more vehicle details as follows:
Age.
1.9, 1.6 or 2.0 HDi,
VIN No ,
RPO No (On Sticker below RHS `A`Post might be something like 09804).
Man or Auto Transmision
ABS Yes or No
EPS Yes or No
Have you checked all the fuses ?

its a 1600 diesel v reg 1999 ,dont know why but it took every fuse out one by one to check them,and they were all ok, then i put the key in to try it and had reset its self turned the key and it started.so i built everything back up and finished the job ,and yes im HAPPY
Find all posts by this user
Add Thank You Quote this message in a reply
12-09-2011, 06:27 PM
Post: #10
RE: heater matrix
[/quote]

its a 1600 diesel v reg 1999 ,dont know why but it took every fuse out one by one to check them,and they were all ok, then i put the key in to try it and had reset its self turned the key and it started.so i built everything back up and finished the job ,and yes im HAPPY
[/quote]
Nice to see you have got it sortedIcon_cheers
Don`t forget in future to follow BSI procedure before disconnecting anything, also be careful if ever fault finding with multimeter,as a multimeter can set an airbag offIcon_sad

2003 Citroën Berlingo 2.0HDi Multispace Desire
Find all posts by this user
Add Thank You Quote this message in a reply


Possibly Related Threads...
Thread: Author Replies Views: Last Post
  Heater control panel removal philip 1 1,220 29-10-2012 09:56 PM
Last Post: taxi
  Winter- Tyres - Heater scotsron 9 3,787 07-12-2011 12:32 AM
Last Post: Ol'Jeffers
  engine heater ian spencer 2 1,733 10-07-2011 07:17 AM
Last Post: Harald Hansen

Forum Jump:


User(s) browsing this thread: 1 Guest(s)
Welcome, Guest
You have to register before you can post on our site.


  

Password
  





Latest Threads
urgent o/s/r door handel ...
Last Post: rustbucket
Today 10:05 PM
» Replies: 0
» Views: 4
new berlingo owner
Last Post: Jed Clampit
Today 10:01 PM
» Replies: 4
» Views: 16
log in problems
Last Post: Jed Clampit
Today 09:55 PM
» Replies: 17
» Views: 4669
Styling Items Available H...
Last Post: Jed Clampit
Today 09:07 PM
» Replies: 2
» Views: 31
key not covered
Last Post: demag
Today 07:25 PM
» Replies: 4
» Views: 156
Would you buy another Mul...
Last Post: demag
Today 07:14 PM
» Replies: 3
» Views: 162
Sliding door window
Last Post: allen1958
Today 06:23 PM
» Replies: 2
» Views: 28
Cold starting problem - 2...
Last Post: carman1949
Today 05:55 PM
» Replies: 20
» Views: 5858
NEW BERLINGO PRODUCTS
Last Post: allvanaccessories
Today 02:20 PM
» Replies: 0
» Views: 20
Accessories for your Berl...
Last Post: allvanaccessories
Today 02:05 PM
» Replies: 0
» Views: 17
Van Accessories
Last Post: allvanaccessories
Today 01:48 PM
» Replies: 0
» Views: 20
Airbag warning light issu...
Last Post: Roadrally
Today 12:27 PM
» Replies: 2
» Views: 142
Bsi control unit
Last Post: Wullie J
Today 12:01 PM
» Replies: 4
» Views: 53

Locations of visitors to this page