Thread Rating:
  • 3 Vote(s) - 2 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Air con
#1
Hi I had my air con regassed last September and now it is blowing hot air (no air con). Not sure if it could need regassing already, so I have tried to do some troubleshooting.
The compressor is kicking in when the dashboard switch is activated and cabin ventilator blower/fan is set to 1,2,3 0r 4. Should the engine radiator cooling fan also be starting to run?
The engine radiator cooling fan does operate when the engine temperature reaches about 95 deg, but I don't know if it should be running when the air con is switched on.
Thanks in advance for any help
2005 Berlingo Multispace 2.0 HDI
Reply
#2
My fan always runs when the air conditioning is on
Reply
#3
Chances are you have a leak.

You will need to have a leak test done to see if this is the case.
Reply
#4
If the clutch comes in when you press the switch, then there is some gas still in the system, however if it is not cold it must be minimal. If the car was gassed that long ago, there will be a small leak, this will be extremely hard to find at first.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)
Welcome, Guest
You have to register before you can post on our site.


  

Password
  





Search Forums

(Advanced Search)

Latest Threads
peugeot charger
Last Post:Jed Clampit
Yesterday 11:28 PM
» Replies: 5
» Views: 129
hello
Last Post:Jed Clampit
Yesterday 11:16 PM
» Replies: 2
» Views: 40
XTR heater control bulb r...
Last Post:VicG
Yesterday 10:57 PM
» Replies: 0
» Views: 12
Fuel consumption
Last Post:ron
Yesterday 09:41 PM
» Replies: 12
» Views: 270
Rear Wiper Motor
Last Post:minisandfords
Yesterday 08:48 PM
» Replies: 2
» Views: 79
Lower Ball Joint
Last Post:brodfather11
Yesterday 08:38 PM
» Replies: 2
» Views: 68
Bottom Ball joint
Last Post:Andyy
Yesterday 08:26 PM
» Replies: 6
» Views: 79
cutting out HDi 1.6 diese...
Last Post:Col
Yesterday 06:15 PM
» Replies: 18
» Views: 1433
Poor cold startup 1.9
Last Post:Top drive
Yesterday 06:10 PM
» Replies: 34
» Views: 802
starting problem
Last Post:brodfather11
Yesterday 03:32 PM
» Replies: 1
» Views: 41

Locations of visitors to this page