Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[Engine] Loud banging, louder when revved.
#1
Hi, I was driving my 04 berlingo 1.9d yesterday and was going around roundabout and got a strong burning smell and loud banging in the engine that got louder when revved. I parked up and the banging is still there. Oil level is fine, no lights came on the dash and the van seemed to be running fine.
Anyone any idea's what it could be, it sounds like a bearing of some sort, I had a nissan almeria before and the big end bearing had gone, this sounds very similar.
Reply
#2
Big end bearings don't bang, they aren't actually that big just called that because they are bigger than the other end (the little end). Check your crank pulley with the auxiliary belt round it and the tensioners.
So where does this bit go then ?
[+] 1 user says Thank You to ffrenchie for this post
Reply
#3
(26-10-2015, 07:50 AM)ffrenchie Wrote:  Big end bearings don't bang, they aren't actually that big just called that because they are bigger than the other end (the little end). Check your crank pulley with the auxiliary belt round it and the tensioners.
Could this of come loose?
Reply
#4


Reply
#5
Video is private?
Reply
#6
First of all you must check the belts auxiliary as per ffrenchie above and af course the most important cam belt,when was this last changed ? Have you overfilled the oil,this can cause noise problems in the higher rev range normally you would get some smoke as well as " big end sounding noise "on the 1.9,sounds horrendous ive been there i useally keep my oil level a little low now.!
Reply
#7
(26-10-2015, 10:35 AM)coys84 Wrote:  


Your video wont play !!
Reply
#8
Video should play now
Reply
#9
Its difficult via audio recording to tell but it sounds like you have more than one noise problem there.

The timing may have jumped a few teeth and the valves could be clattering the pistons?

I would not run it up anymore until the timing has been checked. Sounds too noisy to be the damper pulley, however if the pulley breaks up it can cause the timing to jump teeth.

Like i say its difficult to tell but are any of the injectors blowing?

Like mentioned excess smoke? is the engine chuffing badly?
[+] 1 user says Thank You to polar for this post
Reply
#10
Wipe some oil from the dipstick onto a clean white tissue. Are there any silvery grey particles visible?
It sounds like bottom end to me (although audio recording is no substitute for being there. You can't tell where the sound is coming from on a recording)
[+] 1 user says Thank You to Col for this post
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)
Welcome, Guest
You have to register before you can post on our site.


  

Password
  





Search Forums

(Advanced Search)

Latest Threads
Poor cold startup 1.9
Last Post:CHRISPY59
Today 09:43 PM
» Replies: 24
» Views: 625
2-Button Key Upgrade
Last Post:Matt Haigh
Today 09:24 PM
» Replies: 0
» Views: 15
Reverse light switch prob...
Last Post:polar
Today 09:04 PM
» Replies: 3
» Views: 40
Fuel consumption
Last Post:ron
Today 06:28 PM
» Replies: 9
» Views: 207
peugeot charger
Last Post:Johny555
Today 06:06 PM
» Replies: 2
» Views: 61
Washers not working
Last Post:CourierJim
Today 05:38 PM
» Replies: 3
» Views: 64
Heyup
Last Post:polar
Today 05:03 PM
» Replies: 7
» Views: 307
Amateur radio
Last Post:nicko
Today 04:06 PM
» Replies: 25
» Views: 8269
Apple Carplay
Last Post:Solent
Today 03:58 PM
» Replies: 0
» Views: 26
Haynes manuals - which on...
Last Post:Trevor
Today 03:53 PM
» Replies: 6
» Views: 79

Locations of visitors to this page