Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Where do you get Valve shims ?
#1
Hiya All... Just a few questions..

  I am going to check the valve gaps and want to be prepared..
 I recon the gaps will be well out as I have had the van 65k miles and never checked them..

  I have Googled ( as all good men do ) and seen a method using a sheet of glass and fine wet and dry to thin the shim down. Anyone tried this ?
 Another method is to use a wet stone. Anyone tried this ?
 There was also a method using a but and bolt and a bench grinder.... this method just made me giggle...

Where did you get your shims from ? Are they all 13mm in DW8 and TUV ?


Thanks in Advance..
Reply
#2
A main dealer will sell them for small money.

Plate glass with wet / dry works well too - need a micrometer to verify the size. Time consuming !!!

Bench grinder - forget it !!!

Mileage at 65k ..... doubt they will need doing but measure for peace of mind ( think more of around 100k )

I find that inlet valves tend to close up, my remedy - disable the EGR ( search forum )
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)
Welcome, Guest
You have to register before you can post on our site.


  

Password
  





Search Forums

(Advanced Search)

Latest Threads
peugeot charger
Last Post:Jed Clampit
Yesterday 11:28 PM
» Replies: 5
» Views: 133
hello
Last Post:Jed Clampit
Yesterday 11:16 PM
» Replies: 2
» Views: 44
XTR heater control bulb r...
Last Post:VicG
Yesterday 10:57 PM
» Replies: 0
» Views: 18
Fuel consumption
Last Post:ron
Yesterday 09:41 PM
» Replies: 12
» Views: 276
Rear Wiper Motor
Last Post:minisandfords
Yesterday 08:48 PM
» Replies: 2
» Views: 80
Lower Ball Joint
Last Post:brodfather11
Yesterday 08:38 PM
» Replies: 2
» Views: 73
Bottom Ball joint
Last Post:Andyy
Yesterday 08:26 PM
» Replies: 6
» Views: 84
cutting out HDi 1.6 diese...
Last Post:Col
Yesterday 06:15 PM
» Replies: 18
» Views: 1437
Poor cold startup 1.9
Last Post:Top drive
Yesterday 06:10 PM
» Replies: 34
» Views: 810
starting problem
Last Post:brodfather11
Yesterday 03:32 PM
» Replies: 1
» Views: 45

Locations of visitors to this page