2.0 hdi engine cover

[Ewanm77]

should it have one and does anyone have a pic of one?

[Growler73]

Yes and it looks exactly like this apart from the badge is a Citroen one (this one is from a 2.0 hdi Peugeot partner)

[Image: 58b59d490b8893d49a26a7dbeb53efe7.jpg]

Sent from my SM-N9005 using Tapatalk

[Ewanm77]

thanks
do they cut down engine noise at all?

[Growler73]

Yes providing the clips are all in place.

Sent from my SM-N9005 using Tapatalk

[Ewanm77]

I found one on ebay so ill get it and a new set of clips

[ffrenchie]

I found one on ebay so ill get it and a new set of clips

Get the rubber bobbins that they fasten to as well, they are the reason most people lose the cover when they delaminate. I fitted some little exhaust bobbins instead and use 10mm M6 nuts to hold the cover on. It takes a bit longer to remove but it's a lot more secure. This kind of thing but they were only about 60p each from the local car spares shop.

[Ewanm77]

I was going to order these
http://www.ebay.co.uk/itm/CITROEN-XSARA-...SwyjBW5p4i

[Growler73]

Yes! Get those. I use the same ones. I've not had one break yet. The other ones are as much use as a chocolate fireguard.

Sent from my SM-N9005 using Tapatalk

[ffrenchie]

I was going to order these
http://www.ebay.co.uk/itm/CITROEN-XSARA-...SwyjBW5p4i

That looks like a good alternative. Mine from the local spares shop were Renault exhaust bobbins and they were only about 60p each and if I fitted some wing nuts they would be similar to the eBay item.

[Ewanm77]

it would work out a lot cheaper getting them