Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
2.0 hdi engine cover
#1
should it have one and does anyone have a pic of one?
Reply
#2
Yes and it looks exactly like this apart from the badge is a Citroen one (this one is from a 2.0 hdi Peugeot partner)

[Image: 58b59d490b8893d49a26a7dbeb53efe7.jpg]

Sent from my SM-N9005 using Tapatalk
Reply
#3
thanks
do they cut down engine noise at all?
Reply
#4
Yes providing the clips are all in place.

Sent from my SM-N9005 using Tapatalk
Reply
#5
I found one on ebay so ill get it and a new set of clips
Reply
#6
(11-05-2016, 09:14 PM)Ewanm77 Wrote:  I found one on ebay so ill get it and a new set of clips

Get the rubber bobbins that they fasten to as well, they are the reason most people lose the cover when they delaminate. I fitted some little exhaust bobbins instead and use 10mm M6 nuts to hold the cover on. It takes a bit longer to remove but it's a lot more secure. This kind of thing but they were only about 60p each from the local car spares shop.
So where does this bit go then ?
Reply
#7
I was going to order these
http://www.ebay.co.uk/itm/CITROEN-XSARA-...SwyjBW5p4i
Reply
#8
Yes! Get those. I use the same ones. I've not had one break yet. The other ones are as much use as a chocolate fireguard.

Sent from my SM-N9005 using Tapatalk
Reply
#9
(12-05-2016, 08:26 AM)Ewanm77 Wrote:  I was going to order these
http://www.ebay.co.uk/itm/CITROEN-XSARA-...SwyjBW5p4i

That looks like a good alternative. Mine from the local spares shop were Renault exhaust bobbins and they were only about 60p each and if I fitted some wing nuts they would be similar to the eBay item.
So where does this bit go then ?
Reply
#10
it would work out a lot cheaper getting them
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)
Welcome, Guest
You have to register before you can post on our site.


  

Password
  





Search Forums

(Advanced Search)

Latest Threads
peugeot charger
Last Post:Jed Clampit
Yesterday 11:28 PM
» Replies: 5
» Views: 129
hello
Last Post:Jed Clampit
Yesterday 11:16 PM
» Replies: 2
» Views: 40
XTR heater control bulb r...
Last Post:VicG
Yesterday 10:57 PM
» Replies: 0
» Views: 12
Fuel consumption
Last Post:ron
Yesterday 09:41 PM
» Replies: 12
» Views: 270
Rear Wiper Motor
Last Post:minisandfords
Yesterday 08:48 PM
» Replies: 2
» Views: 79
Lower Ball Joint
Last Post:brodfather11
Yesterday 08:38 PM
» Replies: 2
» Views: 67
Bottom Ball joint
Last Post:Andyy
Yesterday 08:26 PM
» Replies: 6
» Views: 78
cutting out HDi 1.6 diese...
Last Post:Col
Yesterday 06:15 PM
» Replies: 18
» Views: 1433
Poor cold startup 1.9
Last Post:Top drive
Yesterday 06:10 PM
» Replies: 34
» Views: 801
starting problem
Last Post:brodfather11
Yesterday 03:32 PM
» Replies: 1
» Views: 41

Locations of visitors to this page