Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
2002 Berlingo Multispace 1.6 interior lights
#1
It's been a while since my last post or login to the forum, so hello to all again.

Having an issue with the door central locking, lock then immediately unlocks and display saying door open, courtesy lights on, my question is:-

Can someone direct me to the wiring/circuit diagram for the central locking (no deadlocks) and internal door switch wiring colours/no's I've got a Haynes, however, it doesn't show the courtesy light switch wiring, I can trace the wiring but wanted to have something to hand prior to stripping things down and tracing (My suspicion is o/s/f as it's the most used), I've checked continuity of wiring at door hinges and all check out fine even when wiggling wires so know I've an issue at door/lock side of one of the doors, even if someone can give me the pin no id's on the lock modules for the internal switch, I can take it from there, Many thanks in advance guys.
Reply
#2
I've had the same problem in mine: definitely driver's door prime suspect. In my case the internal switch of the lock was okay, but the wire in the door's internal loom wad broken. The wire can be fixed easily, but if the lock is gone, gi to a parts shop
Reply
#3
and buy a pair of door jamb switches (you probably have there ready made holes. Just run a wire to the loom running beside the jamb. Problem solved fot the next fifty years, and definitely cheaper thsn a new lock. Apparently on a lot of cars the internal door levers exercize force on the wiring snd cause wire breackage in time. I had one more broken wire in the electrical locking wiring.....
[+] 1 user says Thank You to Saandy for this post
Reply
#4
(20-06-2016, 05:24 AM)Saandy Wrote:  and buy a pair of door jamb switches (you probably have there ready made holes. Just run a wire to the loom running beside the jamb. Problem solved fot the next fifty years, and definitely cheaper thsn a new lock. Apparently on a lot of cars the internal door levers exercize force on the wiring snd cause wire breackage in time. I had one more broken wire in the electrical locking wiring.....

Had a stroke of luck, passing a scrap merchant and saw a lingo van sitting ready to be taken within, decorators van, Left hand drive to boot, quick look inside and paint everywhere, osf door hardly used 10 minutes to remove it (I always carry a tool kit) £10.00 for mechanism and rods, installed in my lingo now and all working as it should, interior lights and central locking working as intended, well chuffed, thanks for the input though Saandy, maybe of use to others in due course  Wink
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)
Welcome, Guest
You have to register before you can post on our site.


  

Password
  





Search Forums

(Advanced Search)

Latest Threads
Washers not working
Last Post:Redjoe100
Today 07:34 AM
» Replies: 7
» Views: 192
increase in a ratchet-typ...
Last Post:saskak
Today 12:36 AM
» Replies: 7
» Views: 121
DW8 engine tapping
Last Post:Hector Scorn
Today 12:30 AM
» Replies: 0
» Views: 16
Rear Wiper Motor
Last Post:madwelshman
Yesterday 10:42 PM
» Replies: 3
» Views: 116
Heater control unit/resis...
Last Post:mreid63
Yesterday 10:34 PM
» Replies: 5
» Views: 340
Loud beeping from radio u...
Last Post:Tonyash
Yesterday 10:13 PM
» Replies: 0
» Views: 27
Facial light replacement
Last Post:Mike
Yesterday 09:23 PM
» Replies: 11
» Views: 292
Reverse light switch prob...
Last Post:willpisme
Yesterday 08:09 PM
» Replies: 7
» Views: 162
Rear hub nut torque setti...
Last Post:geoff
Yesterday 07:31 PM
» Replies: 4
» Views: 97
Heyup
Last Post:polar
Yesterday 07:18 PM
» Replies: 9
» Views: 374

Locations of visitors to this page