Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Is This Bad workmanship or part failure (09 Clutch)
#1
I posted regarding this issue basically I had person/mechanic install a clutch 
The install or part ! Has failed result clutch failure after 70miles 

It's been a headache from the start but I'm asking for Opinion on this bearing 

He claims bearing was separated when he removed clutch . 
Should the bearing be pressed and not separate ?  What's required to separate ? 

On the bearing are some rather flimsy looking locator tabs , the bearing can only be installed the correct way due to the rectangular locator . The bearing now has only one locator and there's some evidence of chaffing 

Would a poorly seated bearing prevent the clutch engaging ? 

What's your view on the part condition ? 

He's now asking I pay for job again
  I ordered the part and I did this to ensure it was correct , it was done by obtaining part numbers from vin @ dealer parts department . 
Your thoughts and opinions plz 
Thanks
Reply
#2
One picture
   
Reply
#3
    Picky 2 Srry I can't rename them to up on ipad
Reply
#4
    further
Reply
#5
If the parts have failed make a claim against the supplier or manufacturer, BUT my guess is issue is more likely to be with fitting.
2012 Berlingo Multispace VTR 1.6HDI White
Reply
#6
    Separation but no heat
Reply
#7
Pressure plate chaffing ?     
Reply
#8
are they 100% sure they fitted a new bearing with the clutch kit ?
2012 Berlingo Multispace VTR 1.6HDI White
Reply
#9
Valeo is OE.
Looks like bearing not clipped into fork properly
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)
Welcome, Guest
You have to register before you can post on our site.


  

Password
  





Search Forums

(Advanced Search)

Latest Threads
2-Button Key Upgrade
Last Post:Mojow Royle
Today 02:52 PM
» Replies: 1
» Views: 78
Heyup
Last Post:Mojow Royle
Today 02:49 PM
» Replies: 8
» Views: 350
Poor cold startup 1.9
Last Post:Top drive
Today 02:46 PM
» Replies: 36
» Views: 862
Rear hub nut torque setti...
Last Post:El Berlingo
Today 01:14 PM
» Replies: 3
» Views: 62
peugeot charger
Last Post:Jed Clampit
Yesterday 11:28 PM
» Replies: 5
» Views: 173
hello
Last Post:Jed Clampit
Yesterday 11:16 PM
» Replies: 2
» Views: 58
XTR heater control bulb r...
Last Post:VicG
Yesterday 10:57 PM
» Replies: 0
» Views: 41
Fuel consumption
Last Post:ron
Yesterday 09:41 PM
» Replies: 12
» Views: 310
Rear Wiper Motor
Last Post:minisandfords
Yesterday 08:48 PM
» Replies: 2
» Views: 97
Lower Ball Joint
Last Post:brodfather11
Yesterday 08:38 PM
» Replies: 2
» Views: 106

Locations of visitors to this page