Thread Rating:
  • 13 Vote(s) - 2.85 Average
  • 1
  • 2
  • 3
  • 4
  • 5
rev counter not working
#1
I've noticed its been asked before but there's no answer, so has anyone had the following problem and sorted it. The rev counter on the whole has stopped working but sometimes it will spring into life til about 2000 revs then drop to 0 and not work again. Tunnel earth and the 2 at the bottom of the A post checked along with the ones by the light under the bonnet. They were all ok. Any suggestions?
Reply
#2
Hi, if you PM me your vin No. I'll look up the sensors. I think it'll be the flywheel sensor but not sure.
2006 2.0hdi 600 with bench seat.  Cool
Reply
#3
If it helps i've noticed the instrument lights come on and the red warning lights flash, the needles move slightly also on the speedo and rev counter when the keys are'nt in the ignition
Reply
#4
Does it state STOP in red lighted writing on dash? If yes you've had a failure of same thing I had go wrong with mine. X reg 2000 1.8pet Mspace. Not sure what the bit that failed is called but Citroen wanted over a £1000 just for the part alone and fitting it was another £1000. I took it to an electrical expert fairly local to me and they took the part off and got it reprogrammed for £243 pounds including fitting. I think it controls all the engine management etc and links to sensors in fuel guage/temp gauge and all things on dash. The only problem with mine now is temp/fuel dash displays do not work as should as plugs somehow got messed up when reassembling. I can live with it as it is over 10 years old and has been a good car so far.
Reply
#5
No when driving the only problem is the rev counter not working, all the warning lights flash without the key in, it doesnt bleep when the lights are left on either
Reply
#6
(10-03-2012, 12:03 PM)psycho Wrote:  No when driving the only problem is the rev counter not working, all the warning lights flash without the key in, it doesnt bleep when the lights are left on either

Hi
Definitely sounds like same thing I had. You either have to get yours repaired and reset, then refitted, or you need to get a new one fitted, which has to be programed for your berlingo.
Reply
#7
Rainbow 
Hi, I have a 2002 berlingo and the rev counter is not working . where can i locate the sensor and what is the sensor called, is it ? flywheel ,tacho ?
and where can i located and test the sensor.
Reply
#8
Hi, without knowing your engine I can't be sure but usually it's on top of the bell housing and this looks at some magnets which are fixed in the flyweel. There are posts on the forum where these magnets are missing or not there due to changing the flyweel etc. :thumbsup:
2006 2.0hdi 600 with bench seat.  Cool
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)
Welcome, Guest
You have to register before you can post on our site.


  

Password
  





Search Forums

(Advanced Search)

Latest Threads
2012 enterprise berlingo ...
Last Post:Johny555
Today 05:37 PM
» Replies: 9
» Views: 176
2.0 HDi fuel issues as pe...
Last Post:G.mk3
Today 05:28 PM
» Replies: 2
» Views: 22
citroen berlingo desire 1...
Last Post:Jed Clampit
Today 05:22 PM
» Replies: 4
» Views: 91
12v for lighter front
Last Post:ghost123uk
Today 02:59 PM
» Replies: 6
» Views: 143
Insurance!
Last Post:Col
Today 02:57 PM
» Replies: 9
» Views: 879
"Ultimate" type Diesel fu...
Last Post:ghost123uk
Today 02:48 PM
» Replies: 17
» Views: 407
2025 Diesel Ban
Last Post:rnamman
Today 01:58 PM
» Replies: 9
» Views: 143
Alloys
Last Post:Rich Walker
Today 01:36 PM
» Replies: 3
» Views: 120
1.6 16v petrol cambelt
Last Post:sks01773
Today 09:28 AM
» Replies: 4
» Views: 78
Berlingo won't start 2009...
Last Post:brodfather11
Today 06:20 AM
» Replies: 8
» Views: 214

Locations of visitors to this page