Thread Rating:
  • 14 Vote(s) - 2.14 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[Transmission] clutch judder engine rocking
#1
Hi i have a 05 reg 2.0hdi multispace,the clutch judders when pulling away and the engine seems to rock to and frow when on and off the gas the bottom rear mountings looks like a major job as the driveshaft goes through it,any ideas folks ?
Reply
#2
mine does the same pulling away and trying to drive at low revs the car feels like its surging forward /back.
thought it was just a lingo thing
berlingo multispace 53 plate 2.0hdi
Reply
#3
(25-04-2012, 08:11 PM)slightlee Wrote:  mine does the same pulling away and trying to drive at low revs the car feels like its surging forward /back.
thought it was just a lingo thing

I hope its not just a berlingo thing it pretty bad there must be a soloution to this problem
Reply
#4
check the top mountings first, left and right. rock the engine back and forward and any wear on them will show up as excessive movement. they tend to go before the bottom ones. if no wear/movement seen then its a big job if its the bottom one.
It could be a faulty clutch thats causing the problem , if no wear seen on the mountings then check the cluch is ok.

happy juddering ! Confusedillyme:
[+] 1 user says Thank You to brodfather11 for this post
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)
Welcome, Guest
You have to register before you can post on our site.


  

Password
  





Search Forums

(Advanced Search)

Latest Threads
Berlingo won't start 2009...
Last Post:Chri5
Today 12:22 AM
» Replies: 7
» Views: 170
Insurance!
Last Post:fcamp
Yesterday 10:52 PM
» Replies: 6
» Views: 825
citroen berlingo desire 1...
Last Post:sks01773
Yesterday 10:47 PM
» Replies: 2
» Views: 40
1.6 16v petrol cambelt
Last Post:sks01773
Yesterday 10:40 PM
» Replies: 0
» Views: 20
B9 DPF Tank Top-Up
Last Post:Lighty
Yesterday 10:06 PM
» Replies: 5
» Views: 113
Rear light Cluster
Last Post:Peter Guy
Yesterday 09:57 PM
» Replies: 2
» Views: 31
2012 enterprise berlingo ...
Last Post:CourierJim
Yesterday 09:03 PM
» Replies: 6
» Views: 119
Head gasket failure.
Last Post:Civvic
Yesterday 08:08 PM
» Replies: 13
» Views: 361
At last
Last Post:Gerald Bostock
Yesterday 08:06 PM
» Replies: 9
» Views: 330
Conversion from manual to...
Last Post:Civvic
Yesterday 07:58 PM
» Replies: 1
» Views: 89

Locations of visitors to this page