Thread Rating:
  • 10 Vote(s) - 3.3 Average
  • 1
  • 2
  • 3
  • 4
  • 5
horn not working
#1
I've been reading the posts regarding non working horns, and I still can't work out why the horn only works with the ignition key out. This tells me that the horn wiring isn't just wired directly like the Haynes manual shows, it has to be connected in to the ignition circuit somewhere. Does anyone have a correct wiring diagram showing the interconnections that are in the horn circuit?
Reply
#2
Well, there is always the bumper sticker I saw in Reading once - "Horn broken. Watch for finger" Couldn't resist :wave::wave:
2010 Berlingo Multispace HDi 110 with FAP. Persamos green.

[Image: ab197646.gif]
Reply
#3
To be of any assistance to you we will need the model, engine, and year as they all have differences.
Most of the electrics are routed via the BSI and you may want to start with a BSI re-set.
You'll find that a little down this page:
http://www.bba-reman.com/content.aspx?co...ol_failure

It is essential that the procedure is followed to the letter.
Hope this helps. :-)
[fon‌t=Tahoma, Calibri, Verdana, Geneva, sans-serif]The Older I get the Better I Was!  Cool [/font]
[+] 1 user says Thank You to Ol'Jeffers for this post
Reply
#4
(05-07-2012, 01:24 PM)coatess Wrote:  I've been reading the posts regarding non working horns, and I still can't work out why the horn only works with the ignition key out. This tells me that the horn wiring isn't just wired directly like the Haynes manual shows, it has to be connected in to the ignition circuit somewhere. Does anyone have a correct wiring diagram showing the interconnections that are in the horn circuit?


Think you find that when you remove the key, the steering lock bolt must spring out ready to lock the steering wheel.

I found that this was remaking a lost or poor earth connection, hence making the horn work.

Try this to check. With the key in, try the horn. If it doesn't work, then connect a jump lead or similar to the steering knuckle joint down near the pedals and a known earth (I used the door check strap).

No try the horn, if it works then it an earth problem.

My fix was to use a nice think piece of electrical cable and twist it around the steering shaft/rod under the dash and fix the other end to a good earth under the dash. Ever since this fix its been fine and never had issues with MOT
[+] 1 user says Thank You to 800HDI for this post
Reply
#5
Thanks for your replies, I will try these suggestions.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)
Welcome, Guest
You have to register before you can post on our site.


  

Password
  





Search Forums

(Advanced Search)

Latest Threads
Reverse light switch prob...
Last Post:Col
Today 07:22 PM
» Replies: 12
» Views: 243
2004 Berlino Aerial
Last Post:Claydontoby92
Today 07:14 PM
» Replies: 0
» Views: 14
2005 2.0 HDI Siemens pump...
Last Post:Woodyrvf750
Today 07:05 PM
» Replies: 0
» Views: 15
Washers not working
Last Post:Silverberlingo
Today 06:54 PM
» Replies: 10
» Views: 268
Fuse is burning all the t...
Last Post:fernandoblas
Today 05:23 PM
» Replies: 12
» Views: 410
HELP! Smashed passenger w...
Last Post:Sootyfoot
Today 04:31 PM
» Replies: 2
» Views: 67
Diagnostic "gear" / Softw...
Last Post:cancunia
Today 04:19 PM
» Replies: 15
» Views: 612
Poor cold startup 1.9
Last Post:Top drive
Today 02:01 PM
» Replies: 38
» Views: 1031
Berlingo Parts
Last Post:malgpz900
Today 10:20 AM
» Replies: 1
» Views: 86
XTR heater control bulb r...
Last Post:Opensauce
Today 09:19 AM
» Replies: 1
» Views: 80

Locations of visitors to this page