Thread Rating:
  • 7 Vote(s) - 2.71 Average
  • 1
  • 2
  • 3
  • 4
  • 5
No feed to Glow Plugs
#1
Hi all, i have an 04 Berlingo 1.9d which is struggling to start in the mornings, i have noticed that the glow plug light on dashboard is no longer coming on. it went for an MOT and i got the guy to check the glow plugs which were fine but he said there is no feed to them ?? Any ideas if this will be causing the starting issues and how to solve?
Cheers
Reply
#2
Need to check the wiring and relay but where they are situated I don't know.

The older engine definately relied on glow plugs to start, similar to my old Pug 306.
Could always tell when a g.p. was down as started with a miss-fire until cleared and loads of white smoke. If more than one g.p. failed it would struggle or fail to start.
Berlingo Multispace 2.0HDI '54 reg Mediterranean Blue
Reply
#3
Welcome gottagetaname to the BOF...hope you get it sorted.
MPV (My own Personal Vehicle)....2.0 HDi Multispace MPV Mk2 .

I Like Cars,Women,Drink & Motorbikes but not necessarily in that order!
Reply
#4
ok, its had a few wiring issues, the horn was working intermittantly when engine was on however it worked without the key in, i took it to an electrical place and they said it looked like a bad earth so for ease/cost they just re-routed the horn to an independant button on dash.
Reply
#5
Hi, The relay is situated under the battery tray at the back. This is what ensures correct pre/post heat times etc... you can bypass this to check whether it is operational. The glowplugs are connected together by a thick wire which runs to the relay via the plastic manifold above the plugs. This connection can easily be unscrewed and run to the battery + with a jump lead etc. Give it 10 or so seconds to heat the plugs and try and start. If this doesn't work then plugs could still be at fault. Otherwise check all connectors/ wiring from relay to plugs and battery, something could have shaken loose... good luck check these obvious things first though..

adam
Adam..2003..1.9D..LX..Silver Crew Cab Van.....
If at first you don't succeed, destroy all evidence that you tried.
[+] 1 user says Thank You to adam3rdcanvey for this post
Reply
#6
Thanks for the advice i will give it a try!!
[+] 1 user says Thank You to gottagetaname for this post
Reply
#7
cheers bud,

send me a message if you can't find the solution, and i'll try and post some how to photos for ya.
have had many issues with my van but there is always a simple solution!

adam

Adam..2003..1.9D..LX..Silver Crew Cab Van.....
If at first you don't succeed, destroy all evidence that you tried.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)
Welcome, Guest
You have to register before you can post on our site.


  

Password
  





Search Forums

(Advanced Search)

Latest Threads
Repair a manual winder wi...
Last Post:AbneyTeal
Today 12:25 PM
» Replies: 0
» Views: 2
Fuel consumption
Last Post:Wyvern
Today 11:18 AM
» Replies: 6
» Views: 92
12v for lighter front
Last Post:nicko
Today 11:09 AM
» Replies: 16
» Views: 340
1.6 16v petrol cambelt
Last Post:sks01773
Today 10:56 AM
» Replies: 14
» Views: 324
lubricating door
Last Post:sks01773
Today 10:52 AM
» Replies: 3
» Views: 97
how many miles on yours ?
Last Post:Wyvern
Today 10:27 AM
» Replies: 18
» Views: 814
Roof noise
Last Post:Opensauce
Today 09:59 AM
» Replies: 2
» Views: 70
Rear light Cluster
Last Post:Opensauce
Today 09:50 AM
» Replies: 3
» Views: 93
Saying Hello
Last Post:ghost123uk
Today 09:07 AM
» Replies: 2
» Views: 48
Lexia clone that works wi...
Last Post:brajomobil
Today 08:02 AM
» Replies: 59
» Views: 1863

Locations of visitors to this page