Has anyone got a link to a decent wiring diagram?
Haynes are totally useless and does not match anything on my van as regards wire colours etc.
Its mainly for the ignition wiring i'm after as hope to fit a runlock kit this weekend.
What does your insurance say about the Runlock?
Probably the same they'd say if I left the keys in whilst unattended and the fact my tyres aren't the correct load rating
If you're contemplating 'runlock' on a diesel make sure that you
never leave it in bottom gear! I watched a guy who clicked on his key remote
30 yards from his car and stood rooted to the ground when the car took off across
the car park straight into an Alfa-Romeo which had the owner sitting in it!!
He was not a happy bunny.....
[font=Tahoma, Calibri, Verdana, Geneva, sans-serif]The Older I get the Better I Was! [/font]
(12-10-2012, 08:08 PM)800HDI Wrote: Probably the same they'd say if I left the keys in whilst unattended and the fact my tyres aren't the correct load rating
Do not write below this line. Office use only.
No chance of leaving it in gear really as its activated once handbrake is on and in neutral
Shhhhhhh too right lol
13-10-2012, 03:52 PM
(This post was last modified: 13-10-2012, 04:17 PM by Rustscrat.)
I'll see what I can dig out.
This any use?
(Size: 26.77 KB / Downloads: 60)
2006 2.0hdi 600 with bench seat.
Managed to sort it this morning. In the end its only a couple of wires, all the over sleeving made it look more complicated than it actually is.
Thanks again though
19-10-2012, 01:23 PM
(This post was last modified: 19-10-2012, 01:23 PM by BlingoBlue.)
nICE DIAGRAM THANKS.
Nice diagram thanks.
The following 1 user says Thank You to BlingoBlue for this post:1 user says Thank You to BlingoBlue for this post