Thread Rating:
  • 14 Vote(s) - 2.71 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Ran out of fuel, now wont start. (tried bleeding)
#1
Hi, having trouble with my 03 berlingo van so thought id see if anyone on here could help.
I foolishly ran my van out of fuel last night, well I assume its out of fuel because Its well below red and it cut out so Im pretty sure it is.
Ive put 5 litres in, Ive tried bleeding it and still no joy, ive been towed and attempted to bump it but its not even firing? any sort of advice/help would be great. Thanks, Lee
Reply
#2
Hi Lee,
I asume it's a diesel (Mines petrol but I have a diesel LandRover) Does it need bleeding? Check the manual.
HTH,
Griff
OOps Didn't see last bit of tilte. Sorry
Landmark
Ex 1.4 Berlingo Multispace
Reply
#3
(22-10-2012, 11:16 AM)Landmark Wrote:  Hi Lee,
I asume it's a diesel (Mines petrol but I have a diesel LandRover) Does it need bleeding? Check the manual.
HTH,
Griff
OOps Didn't see last bit of tilte. Sorry

Well I was bleeding it at half 11 last night with my mother giving me a hand and It did go for 10 seconds, then I noticed fuel squirting out one of the injectors so turned it off to nip the nut back up, done that and it wouldnt go again then. So i just gave up last night and had a crack at it this morning, but nothing!!!!!!!!
Reply
#4
I can only give a wild guess that the fuel system is drawing air, did you notice any irregular running before it ran out of fuel? Try putting quite a bit more fuel in.
Hope you get back on the road pronto.
Reply
#5
(22-10-2012, 11:43 AM)CaptainKirk Wrote:  I can only give a wild guess that the fuel system is drawing air, did you notice any irregular running before it ran out of fuel? Try putting quite a bit more fuel in.
Hope you get back on the road pronto.

No, was a clean cut out. YEah think ill chuck a few more cans in there just to be safe, cheers
Reply
#6
They do take a lot of bleeding , It suggests to me that when the injector pipe was open it was letting the air in the system move to where it could get out, Open all the injector pipes and turn it over a few times . If you can see the fuel come out , keep turning the engine until it stops (air coming out ) then fuel comes again . Tighen up pipes and try again . Its messy but the air has to be removed
It will just be air in the system, if anything more serious then it would not have started. I'm assuming that you've bled it all up to the fuel pump.

:thumbsup:
Reply
#7
So if i crack all the injectors loose, i can go turn it over a few times, stop, and tighten them back up? or does the engine need to swinging over while there be tightened back up?
Reply
#8
So if i crack all the injectors loose, i can go turn it over a few times, stop, and tighten them back up? Yes

Does nt really matter how its done as long as the air is pumped out. Try turning over a few times then tighten up two , turn over again and if it shows signs of starting the tighen up the other two. It does'nt need to be turning when tightening them up. Once you have fuel at one or two pipes it will start but until the other pipes are air free it will run rough then the act of running will pump out all the air itself.
Reply
#9
I presume its a 1.9 D, front left of the engine, when standing at the front looking under the bonnet are 2 fuel pipes, smaller dia one is the return, disconnect it,and the side coming out of the pump shove it in a small container/bottle, them pump the primer on the fuel filter till no air is seen in bottle.
Reconnect pipe and pump the primer a couple of times untill it goes hard and the van should start after a couple of cranks.
Reply
#10
Managed to get air out of the both pipes but stil f-all!! batterys more or less flat now so Ill leave it charge up and give it one more go...Should i try bleeding the injectors again? or am I looking at a bill from the garage?
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)
Welcome, Guest
You have to register before you can post on our site.


  

Password
  





Search Forums

(Advanced Search)

Latest Threads
Heated wing mirrors
Last Post:3rensho
Today 06:00 AM
» Replies: 1
» Views: 30
1.6 hdi 90bhp Turbo and i...
Last Post:Floydster
Yesterday 11:07 PM
» Replies: 1
» Views: 86
how many miles on yours ?
Last Post:Silverberlingo
Yesterday 10:59 PM
» Replies: 17
» Views: 773
1.6 16v petrol cambelt
Last Post:geoff
Yesterday 10:24 PM
» Replies: 5
» Views: 135
Door locking but unlocked
Last Post:DanielEZY0252
Yesterday 09:45 PM
» Replies: 0
» Views: 21
12v for lighter front
Last Post:Jed Clampit
Yesterday 09:07 PM
» Replies: 8
» Views: 201
2.0 HDi fuel issues as pe...
Last Post:G.mk3
Yesterday 07:17 PM
» Replies: 5
» Views: 77
zx1 extralube
Last Post:sks01773
Yesterday 06:07 PM
» Replies: 0
» Views: 54
citroen berlingo desire 1...
Last Post:sks01773
Yesterday 05:57 PM
» Replies: 5
» Views: 152
2012 enterprise berlingo ...
Last Post:Johny555
Yesterday 05:37 PM
» Replies: 9
» Views: 213

Locations of visitors to this page