Thread Rating:
  • 10 Vote(s) - 3 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Fault Codes
#1
I have a 57 1.6HDi that I bought a few months back. When I got it I checked for fault codes and it was clear.
Yesterday the engine light came on and I have a shed load of fault codes.
P2111 - P0409 - P1161 - P0488 - P1162 - P0490 - P0401
The van is driving fine at the moment and did 100 miles today without any issues. I suspect that one issue has caused all the faults, but who knows. Has anyone come across this before?
Reply
#2
A good place to start:-

http://www.permoveo.ltd.uk/tabid/122/OBD...fault.aspx
Reply
#3
I suspect all the fault codes are being caused by just one fault. Most of them relate to the EGR valve, but I have removed this and it is clean as a whistle and free, perhaps too clean.
I note that it is spring loaded so that it remains closed as a default, is there some other sensor that influences the operation of the EGR valve.
Also where is the engine type code on these?
Reply
#4
The EGR is operated by a solenoid and whether it has opened correctly is monitored by the MAF sensor on the inlet
Reply
#5
Fitted a replacement EGR valve as mine had a hole worn through the plastic cover on the solenoid from the air box bubbing on it. The faults are still there, ho hum!
I suspect that the throttle body (fault code P1161 and 1162) is the fault and not sending the correct signal to the EGR via the ECU, so now have one of them on order. Thank god for ebay.

CORRECTION! fault P2111 Throttle Actuator Control System - Stuck Open, P1161 (throttle position I think), and P0488 Exhaust Gas Recirculation Throttle Position Control Range/Performance are still there, but the others have not come back, let's see whata throttle body will do.
Reply
#6
Fitted a replacement throttle body and all seems well! Fingers crossed.
Reply
#7
(18-12-2012, 09:15 PM)JohnM Wrote:  Fitted a replacement throttle body and all seems well! Fingers crossed.

Let's hope you have cracked it.:woop:
Strawberry flavoured windows  Dodgy
Reply
#8
When I had the replacement throttle body to compare with the old one it was obvious that there was a problem with the throttle flap.
This van is only five years old with 70,000 miles on it and I've had a few problems since I got it, wheel bearing run dry, steering U/J seizing up, crank sensor intermittent fault, and this problem with the throttle body also the indicator stalk is starting with the floppy issue that plagues these.
I think it is a great van, but I'm not sure about Citroen build quality, I think it's a Caddy next time.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)
Welcome, Guest
You have to register before you can post on our site.


  

Password
  





Search Forums

(Advanced Search)

Latest Threads
peugeot charger
Last Post:Jed Clampit
Yesterday 11:28 PM
» Replies: 5
» Views: 133
hello
Last Post:Jed Clampit
Yesterday 11:16 PM
» Replies: 2
» Views: 44
XTR heater control bulb r...
Last Post:VicG
Yesterday 10:57 PM
» Replies: 0
» Views: 18
Fuel consumption
Last Post:ron
Yesterday 09:41 PM
» Replies: 12
» Views: 276
Rear Wiper Motor
Last Post:minisandfords
Yesterday 08:48 PM
» Replies: 2
» Views: 80
Lower Ball Joint
Last Post:brodfather11
Yesterday 08:38 PM
» Replies: 2
» Views: 73
Bottom Ball joint
Last Post:Andyy
Yesterday 08:26 PM
» Replies: 6
» Views: 84
cutting out HDi 1.6 diese...
Last Post:Col
Yesterday 06:15 PM
» Replies: 18
» Views: 1437
Poor cold startup 1.9
Last Post:Top drive
Yesterday 06:10 PM
» Replies: 34
» Views: 810
starting problem
Last Post:brodfather11
Yesterday 03:32 PM
» Replies: 1
» Views: 45

Locations of visitors to this page