My rev counter doesn't work. Is there a common issue or any pointers to where the sensor/connectors are?
Ive had a look through my haynes manual and that was about as much use as a chocolate teapot about rev counters. Lets hope rustscrat comes along to point you in the right direction.
Are we there yet????? No we fecking ain`t gggggrrrrrrr
Ex 1.6hdi van now 3 seater 1.4 multispace
The following 1 user says Thank You to Tomcat3 for this post:1 user says Thank You to Tomcat3 for this post
Thanks for the reply anyway as I was considering buying a Haynes to help me out with it but guess I will wait for my next fault before shelling out on one.
Hi, This is for the 1.9D XUD9 engine, non Bsi.
Item 1400 is the sensor for the tacho, described as a "Top dead centre sensor".
You should be able to check this with an ohm meter of some kind.
Two of the 3 pins should read approx 200 ohms if I can remember.
Think there is another post with a link to a you tube vid. about this.
2006 2.0hdi 600 with bench seat.
Thanks very much! I will check it out.
The following 1 user says Thank You to TarkMalbot for this post:1 user says Thank You to TarkMalbot for this post