04-02-2013, 09:22 PM
Been lurking about on here for while know and the site has been a good sorce of info so far and was hoping for any input or tips on my job for tomorrow.
Have had a couple of problems already with my 09/59 850lx 90hp van which ive owned for approx 6-7 months.
Clutch release bearing fell to bits within a week of owning it thankfully the garage i bought it from sorted this needed new release bearing,clutch & flywheel.
Then just after new year had antipolution come up on the display replaced fuel filter and fuel rail sensor sorted that out which was a lovely job to do when it was snowing
now onto the job for tomorrow to cut a long story short local tyre place has cross threaded two rear wheel nuts which has nakered the threads in the disc's so tomorrow ive got new disc's and pads to fit and this is where im after some info. Ive done plenty of disc's & pads before but ive never come across this type of disc that has the bearing built into the back of it it all looks pretty straight forward to do but just thought id ask if the is anything that i should be aware of before making a start tomorrow
Thanks in advance
Gary
Have had a couple of problems already with my 09/59 850lx 90hp van which ive owned for approx 6-7 months.
Clutch release bearing fell to bits within a week of owning it thankfully the garage i bought it from sorted this needed new release bearing,clutch & flywheel.
Then just after new year had antipolution come up on the display replaced fuel filter and fuel rail sensor sorted that out which was a lovely job to do when it was snowing
now onto the job for tomorrow to cut a long story short local tyre place has cross threaded two rear wheel nuts which has nakered the threads in the disc's so tomorrow ive got new disc's and pads to fit and this is where im after some info. Ive done plenty of disc's & pads before but ive never come across this type of disc that has the bearing built into the back of it it all looks pretty straight forward to do but just thought id ask if the is anything that i should be aware of before making a start tomorrow
Thanks in advance
Gary