Thread Rating:
  • 4 Vote(s) - 2.75 Average
  • 1
  • 2
  • 3
  • 4
  • 5
oil leak
#1
hi guys hoping for some help with an oil leak! I have located the oil leak it is coming from behind the oil filter but not the oil filter it is seeping from the part that the oil filter is screwed onto... I have no idea what this part is called so am unable to buy a replacement seal or whatever it is lol help needed... thanks in advance
Reply
#2
Hi there, the oil filter is screwed on to the oil cooler from what I can gather, there is a sealing ring between the cooler and the block. Could the oil filter just need a bit of a turn to seal it? Hope this is of some help. Dave
[fon‌t=Verdana]Smile it's already happened! [/font]Big Grin
Reply
#3
i have tried turning it but it seems tight, and there is no oil leaking from the front it is down the back. it is where the cooler meets the engine. i will look for this seal at a parts place. is it a gasket or an "o"ring type seal. or just a rubber
Reply
#4
Hi There, just had a look in the manual and all it says is "sealing ring" so not sure. Dave
[fon‌t=Verdana]Smile it's already happened! [/font]Big Grin
Reply
#5
cheers dave thanks very much. i will drain oil and water and strip it all down and have a good look and clean it all up, hopefully i can fix it! suppose i can have a good look over the cooler while i have it off
Reply
#6
It's going to be either a square section seal or an O-ring.
[+] 1 user says Thank You to addo for this post
Reply
#7
This is for a DW10 engine. Note there are two different sizes of seals. Confusedalut:

.pdf   Oil filter cooling.pdf (Size: 90.51 KB / Downloads: 11)
2006 2.0hdi 600 with bench seat.  Cool
[+] 1 user says Thank You to Rustscrat for this post
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)
Welcome, Guest
You have to register before you can post on our site.


  

Password
  





Search Forums

(Advanced Search)

Latest Threads
increase in a ratchet-typ...
Last Post:saskak
Today 05:31 PM
» Replies: 3
» Views: 53
New owner
Last Post:SheilaAnn
Today 04:33 PM
» Replies: 12
» Views: 558
Repair a manual winder wi...
Last Post:Col
Today 04:26 PM
» Replies: 3
» Views: 76
2-Button Key Upgrade
Last Post:Mojow Royle
Today 02:52 PM
» Replies: 1
» Views: 83
Heyup
Last Post:Mojow Royle
Today 02:49 PM
» Replies: 8
» Views: 354
Poor cold startup 1.9
Last Post:Top drive
Today 02:46 PM
» Replies: 36
» Views: 872
Rear hub nut torque setti...
Last Post:El Berlingo
Today 01:14 PM
» Replies: 3
» Views: 68
peugeot charger
Last Post:Jed Clampit
Yesterday 11:28 PM
» Replies: 5
» Views: 177
hello
Last Post:Jed Clampit
Yesterday 11:16 PM
» Replies: 2
» Views: 59
XTR heater control bulb r...
Last Post:VicG
Yesterday 10:57 PM
» Replies: 0
» Views: 45

Locations of visitors to this page