Thread Rating:
  • 3 Vote(s) - 3 Average
  • 1
  • 2
  • 3
  • 4
  • 5
BSI Probs Still !!!!!
#1
Hi folks,i will start from the beginning my Multispace wouldnt start nothing when you turn the key,thought it must be battery,went with a jump start fine,couple of hours later nothing again. Purchased new battery put it on went to work can home fine,next morn same problem.This is when i joined the forum and found out about the BSI unit and procedures you have to do to reset them. Followed them but still same problem but goes with a jump can any one please advise pulling last bit of hair out !!!! Many thanks Kenny .
Reply
#2
Hi Lowrider,
As you can start with a jump I'm assuming the electrical connections & starter motor etc are ok. Assuming the battery is not defective, to me it sounds as if it's not being charged. If you have acces to a multimeter check the voltage w/out the engine running = about 12.5v. With engine running (Switch all auxillaries off) it should be about 14.5v. If not the alternater's not working.
The more technically minded will be along soon!
HTH,
Griff
Landmark
Ex 1.4 Berlingo Multispace
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)
Welcome, Guest
You have to register before you can post on our site.


  

Password
  





Search Forums

(Advanced Search)

Latest Threads
Berlingo won't start 2009...
Last Post:Chri5
Today 12:22 AM
» Replies: 7
» Views: 170
Insurance!
Last Post:fcamp
Yesterday 10:52 PM
» Replies: 6
» Views: 825
citroen berlingo desire 1...
Last Post:sks01773
Yesterday 10:47 PM
» Replies: 2
» Views: 40
1.6 16v petrol cambelt
Last Post:sks01773
Yesterday 10:40 PM
» Replies: 0
» Views: 20
B9 DPF Tank Top-Up
Last Post:Lighty
Yesterday 10:06 PM
» Replies: 5
» Views: 113
Rear light Cluster
Last Post:Peter Guy
Yesterday 09:57 PM
» Replies: 2
» Views: 31
2012 enterprise berlingo ...
Last Post:CourierJim
Yesterday 09:03 PM
» Replies: 6
» Views: 119
Head gasket failure.
Last Post:Civvic
Yesterday 08:08 PM
» Replies: 13
» Views: 361
At last
Last Post:Gerald Bostock
Yesterday 08:06 PM
» Replies: 9
» Views: 330
Conversion from manual to...
Last Post:Civvic
Yesterday 07:58 PM
» Replies: 1
» Views: 89

Locations of visitors to this page