Thread Rating:
  • 35 Vote(s) - 2.83 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Door Handle Problem
#1
Hi all,

I'm a new convert to Berlingo's having recently bought a 53 plate 1.9D Multispace Forte and I must say I'm mightily impressed!
However, the rear offside sliding door handle isn't working, it's loose and floppy! I assume this is because the cable has snapped or has worked itself loose.
My question is: Do I need to remove the sliding door in order to gain access to and remove the door card and then fix the cable or can the door be kept on (but shut) to remove the door card etc?
Any advice would be appreciated, thanks in advance.
Reply
#2
Hi and welcome. The door in theory has to be removed from the vehicle....

However there are some checks you can make, if you remove the interior door card with door closed and examine the link rods on the lock. One, or both may be disconnected or broken and can be renewed or repaired depending on condition.

This is the first check I would make... Good luckSmile
Adam..2003..1.9D..LX..Silver Crew Cab Van.....
If at first you don't succeed, destroy all evidence that you tried.
[+] 2 users say Thank You to adam3rdcanvey for this post
Reply
#3
Thanks Adam, that'll be my first job in the morning!
Reply
#4
(12-04-2011, 08:38 PM)NewBerlingDriver Wrote:  My question is: Do I need to remove the sliding door in order to gain access to and remove the door card and then fix the cable or can the door be kept on (but shut) to remove the door card etc?
Any advice would be appreciated, thanks in advance.

No. This is not necessary.
Just sit on a rear seat, close the door and do what you want
[+] 2 users say Thank You to pk7478 for this post
Reply
#5
Thanks for that, not had the chance to do it yet due to work etc etc etc but will certainly give it a go. Cheers.
Reply
#6
Well chaps, finally had an hour or so to spare to look at the door handle problem.
Thanks to PK7478 and Adam, I didn't have to remove the door, just popped off the grommets, undid a couple of screws and removed the door card; to find ................... nothing wrong at all!!
Further checks were then made and I ultimately removed the actual handle/lock, again all looked well but the handle was still flapping. With a little back-engineering I finally discovered that the graphite? barrel through the flapping handle had sheared; something that couldn't be repaired by me.
I called my local Citroen parts garage and found that the barrel isn't supplied on it's own so a new handle and casing would need to be bought, then the correct colour sprayed blah blah blah; all at a cost of £76.02! Suffice to say, I didn't bother.
A search online took me to fleabay and low and behold, a nice chappie in Poland is selling the barrels on their own for a tenner; should have gone to ebay first!
I ordered one and it's lovely (maybe I should've ordered two?!)

Thanks again for your advice chaps.
[+] 2 users say Thank You to NewBerlingDriver for this post
Reply
#7
Its a common problem I've had it happen on 2 bingos now. At least it is an easy fix though! :lol:
1.9d Mk2 (M59/BE4/5) with battle scars from a conservatory attack. Previously owned a 1.4i Mk2 Forte.Confusedalut:
Reply
#8
(10-05-2011, 09:11 PM)divingscubaboy Wrote:  Its a common problem I've had it happen on 2 bingos now. At least it is an easy fix though! :lol:

What did you do with your two when this happened? Px
Reply
#9
(04-08-2011, 01:26 PM)paula Wrote:  
(10-05-2011, 09:11 PM)divingscubaboy Wrote:  Its a common problem I've had it happen on 2 bingos now. At least it is an easy fix though! :lol:

What did you do with your two when this happened? Px

scubaboy is an active member so he should be along shortly Smile
Want Help with the Forum? Read Help Documents Here
 [Image: mybbsig.php]

Reply
#10
I take it you can open the door from the inside? if so it sounds like the pin that holds the outside handle has snapped. The lower part of this activates the latching mechanism. They're impossible to get in the uk without getting shafted. Fleabay sells the pins for a tenner or so. I got mine from Poland although I did have to dress them a little with a file as they're fairly rough cast. If you're fairly handy and have some general tools it takes around 45 mins. You will need some torx bits! Any ? ? ? give me a shout. Do a fleabay search for 'citroen berlingo door handle pin' there are 3 listings now.
1.9d Mk2 (M59/BE4/5) with battle scars from a conservatory attack. Previously owned a 1.4i Mk2 Forte.Confusedalut:
[+] 1 user says Thank You to divingscubaboy for this post
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)
Welcome, Guest
You have to register before you can post on our site.


  

Password
  





Search Forums

(Advanced Search)

Latest Threads
Heated wing mirrors
Last Post:Bricky Ken
Yesterday 11:57 PM
» Replies: 0
» Views: 15
1.6 hdi 90bhp Turbo and i...
Last Post:Floydster
Yesterday 11:07 PM
» Replies: 1
» Views: 81
how many miles on yours ?
Last Post:Silverberlingo
Yesterday 10:59 PM
» Replies: 17
» Views: 765
1.6 16v petrol cambelt
Last Post:geoff
Yesterday 10:24 PM
» Replies: 5
» Views: 114
Door locking but unlocked
Last Post:DanielEZY0252
Yesterday 09:45 PM
» Replies: 0
» Views: 11
12v for lighter front
Last Post:Jed Clampit
Yesterday 09:07 PM
» Replies: 8
» Views: 183
2.0 HDi fuel issues as pe...
Last Post:G.mk3
Yesterday 07:17 PM
» Replies: 5
» Views: 69
zx1 extralube
Last Post:sks01773
Yesterday 06:07 PM
» Replies: 0
» Views: 42
citroen berlingo desire 1...
Last Post:sks01773
Yesterday 05:57 PM
» Replies: 5
» Views: 133
2012 enterprise berlingo ...
Last Post:Johny555
Yesterday 05:37 PM
» Replies: 9
» Views: 211

Locations of visitors to this page