Thread Rating:
  • 4 Vote(s) - 4.5 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Alloy wheel hassle
#1
Hi,
I picked up a set of refurbished saxo oem alloys from fleabay dirt cheap. When I fitted them on my mark 2 berlingo I found the hub dosn't reach the wheel center bore
I understand you can get hub spigots but I don't know what size. I think the hub is 65.1mm but not sure about the wheel. Any help would be great. I'm not keen on wheel wobble at 70!
Reply
#2
Check it with a feeler gauge and buy spigot rings to suit. You don't say what the wheel centre bore is but any Citroen wheel should be 65.1mm. Ford use same stud spacing but the centre is smaller.
So where does this bit go then ?
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)
Welcome, Guest
You have to register before you can post on our site.


  

Password
  





Search Forums

(Advanced Search)

Latest Threads
Poor cold startup 1.9
Last Post:Top drive
Today 07:56 AM
» Replies: 31
» Views: 691
Washers not working
Last Post:Redjoe100
Today 07:55 AM
» Replies: 4
» Views: 81
peugeot charger
Last Post:3rensho
Today 06:46 AM
» Replies: 3
» Views: 81
Aftermarket radio stalk C...
Last Post:Matt Haigh
Yesterday 11:53 PM
» Replies: 7
» Views: 251
Reverse light switch prob...
Last Post:willpisme
Yesterday 10:02 PM
» Replies: 4
» Views: 64
Carpet
Last Post:Shaunchippy95
Yesterday 09:50 PM
» Replies: 0
» Views: 33
2-Button Key Upgrade
Last Post:Matt Haigh
Yesterday 09:24 PM
» Replies: 0
» Views: 35
Fuel consumption
Last Post:ron
Yesterday 06:28 PM
» Replies: 9
» Views: 217
Heyup
Last Post:polar
Yesterday 05:03 PM
» Replies: 7
» Views: 310
Amateur radio
Last Post:nicko
Yesterday 04:06 PM
» Replies: 25
» Views: 8288

Locations of visitors to this page