Thread Rating:
  • 1 Vote(s) - 5 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Tow bar success?
#1
I became interested in the Forum because I needed to fit a tow bar to my newly acquired 52-plated M59. I had already pre-wired the electrics to a connector block, behind the LH rear trim panel, using the permanent live feed to the rear wiper motor to power the by-pass relay and trailer indicators. I ordered a Titan tow-bar (£63.40), from PF Jones, during Tuesday lunch time; it arrived Thursday complete with ball, cover and 12N electrics (socket, fixing plate, cable & buzzer). I reversed the vehicle onto some bricks and, lying on a bit of old hardboard, was able to fit the bar reasonably easily (only banging my head once, which is pretty good for me). The 7-core went up through a convenient grommet below the back of the lamp cluster and connected to my block. The buzzer was inserted in the block wiring and, hey-presto, I probably saved myself couple of hundred quid.
Now what shall I tow?
   
Reply
#2
Very tidy, ours already had the towbar fitted and it tows our Combi Camp trailer tent nicely. Only thing I would like to do is quieten the indicator buzzer down a bit, it's very loud.
So where does this bit go then ?
Reply
#3
(04-08-2013, 05:22 PM)veebee Wrote:  I became interested in the Forum because I needed to fit a tow bar to my newly acquired 52-plated M59. I had already pre-wired the electrics to a connector block, behind the LH rear trim panel, using the permanent live feed to the rear wiper motor to power the by-pass relay and trailer indicators. I ordered a Titan tow-bar (£63.40), from PF Jones, during Tuesday lunch time; it arrived Thursday complete with ball, cover and 12N electrics (socket, fixing plate, cable & buzzer). I reversed the vehicle onto some bricks and, lying on a bit of old hardboard, was able to fit the bar reasonably easily (only banging my head once, which is pretty good for me). The 7-core went up through a convenient grommet below the back of the lamp cluster and connected to my block. The buzzer was inserted in the block wiring and, hey-presto, I probably saved myself couple of hundred quid.
Now what shall I tow?

Which tow bar was it?  They don't show one labelled Titan and i'd like to use the same if you've found one that works well.
Reply
#4
Used PF Jones for my last 5 towbars and wiring kits.
Never had a problem with them.  Excellent value.
Malcolm.
2001 1.9D Multispace.
Diagbox diagnostics in Northumberland.
Reply
#5
(08-03-2016, 01:50 PM)malgpz900 Wrote:  Used PF Jones for my last 5 towbars and wiring kits.
Never had a problem with them.  Excellent value.
Malcolm.
So just one of the listed four and using their universal electrics kit that comes with it?  Where the instructions good?
Reply
#6
(08-03-2016, 03:16 PM)jonititan Wrote:  
(08-03-2016, 01:50 PM)malgpz900 Wrote:  Used PF Jones for my last 5 towbars and wiring kits.
Never had a problem with them.  Excellent value.
Malcolm.
So just one of the listed four and using their universal electrics kit that comes with it?  Where the instructions good?
Hardest part of wiring is getting the supply from the existing wiring looms. Back of light clusters with multimeter soon sorts it.
Malcolm.
2001 1.9D Multispace.
Diagbox diagnostics in Northumberland.
Reply
#7
(08-03-2016, 03:50 PM)malgpz900 Wrote:  
(08-03-2016, 03:16 PM)jonititan Wrote:  
(08-03-2016, 01:50 PM)malgpz900 Wrote:  Used PF Jones for my last 5 towbars and wiring kits.
Never had a problem with them.  Excellent value.
Malcolm.
So just one of the listed four and using their universal electrics kit that comes with it?  Where the instructions good?
Hardest part of wiring is getting the supply from the existing wiring looms.  Back of light clusters with multimeter soon sorts it.
Malcolm.

Thanks sounds good.  I might give it a try in a month or so.  My car is a 2004 1.9D so probably very similar to yours.  It has "forte" on the side but i don't know if that means anything.
Reply
#8
(09-03-2016, 05:26 PM)jonititan Wrote:  
(08-03-2016, 03:50 PM)malgpz900 Wrote:  
(08-03-2016, 03:16 PM)jonititan Wrote:  
(08-03-2016, 01:50 PM)malgpz900 Wrote:  Used PF Jones for my last 5 towbars and wiring kits.
Never had a problem with them.  Excellent value.
Malcolm.
So just one of the listed four and using their universal electrics kit that comes with it?  Where the instructions good?
Hardest part of wiring is getting the supply from the existing wiring looms.  Back of light clusters with multimeter soon sorts it.
Malcolm.

Thanks sounds good.  I might give it a try in a month or so.  My car is a 2004 1.9D so probably very similar to yours.  It has "forte" on the side but i don't know if that means anything.

Yeah mine is the forte model as well. As long as you don't have bulb failure warning on yours you should be OK.
Malcolm.
2001 1.9D Multispace.
Diagbox diagnostics in Northumberland.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)
Welcome, Guest
You have to register before you can post on our site.


  

Password
  





Search Forums

(Advanced Search)

Latest Threads
Reverse light switch prob...
Last Post:willpisme
Today 08:09 PM
» Replies: 7
» Views: 138
increase in a ratchet-typ...
Last Post:saskak
Today 07:47 PM
» Replies: 5
» Views: 71
Rear hub nut torque setti...
Last Post:geoff
Today 07:31 PM
» Replies: 4
» Views: 75
Heyup
Last Post:polar
Today 07:18 PM
» Replies: 9
» Views: 365
New owner
Last Post:SheilaAnn
Today 04:33 PM
» Replies: 12
» Views: 569
Repair a manual winder wi...
Last Post:Col
Today 04:26 PM
» Replies: 3
» Views: 84
2-Button Key Upgrade
Last Post:Mojow Royle
Today 02:52 PM
» Replies: 1
» Views: 87
Poor cold startup 1.9
Last Post:Top drive
Today 02:46 PM
» Replies: 36
» Views: 878
peugeot charger
Last Post:Jed Clampit
Yesterday 11:28 PM
» Replies: 5
» Views: 179
hello
Last Post:Jed Clampit
Yesterday 11:16 PM
» Replies: 2
» Views: 60

Locations of visitors to this page