Thread Rating:
  • 4 Vote(s) - 3.5 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Bent arm at bottom of drop-link
Hello again.
Having just got a pair of new drop-links, followed by a look-see with the wheel off I noticed the bottom joint of the 'noisy' link is connected at a steep angle to the 'arm' coming from under the car..?
This 'arm' is looking like it's been previously bent hence when it mates with the drop-link it's not a good fit IMO.
What is this arm called? Will it 'bend' back so the drop-link ball-joint sits at 90' (not 45') to the drop-link again ..or is this arm sprung-steel & it's a replacement-item..?
(Cannot find any reference to this 'lower arm' anywhere..??
That is your anti-roll bar. When the car is lifted at the front, it will poke downwards pronouncedly.

Yes, it's possible to distort the anti-roll bar however the Berlingo ones are quite thick and thus among the harder ones to damage.

Forum Jump:

Users browsing this thread: 1 Guest(s)
Welcome, Guest
You have to register before you can post on our site.



Search Forums

(Advanced Search)

Latest Threads
Rear hub nut torque setti...
Last Post:El Berlingo
Today 11:58 AM
» Replies: 11
» Views: 164
temperatue dial
Last Post:polar
Today 11:47 AM
» Replies: 1
» Views: 17
Loud beeping from radio u...
Last Post:Tree
Today 08:35 AM
» Replies: 2
» Views: 63
DW8 engine tapping
Last Post:brodfather11
Today 08:30 AM
» Replies: 1
» Views: 44
Washers not working
Last Post:Luis Rosa
Today 07:47 AM
» Replies: 8
» Views: 212
increase in a ratchet-typ...
Last Post:saskak
Today 12:36 AM
» Replies: 7
» Views: 140
Rear Wiper Motor
Last Post:madwelshman
Yesterday 10:42 PM
» Replies: 3
» Views: 121
Heater control unit/resis...
Last Post:mreid63
Yesterday 10:34 PM
» Replies: 5
» Views: 344
Facial light replacement
Last Post:Mike
Yesterday 09:23 PM
» Replies: 11
» Views: 305
Reverse light switch prob...
Last Post:willpisme
Yesterday 08:09 PM
» Replies: 7
» Views: 172

Locations of visitors to this page