MOT FAIL

[addo]

They are a right pain to install, and then the bleed-up takes forever. I shudder to think what UK salt might mean the unions look like. Seriously, allow quite a few hours for this one unless you can reverse pressure bleed or vac from the cylinders up to the reservoir.

[geoff]

Taking the caps lock button off to type in lower case usually helps to pass the MOT as people can read your postings easier and then reply more often.... hint :whistle::whistle:

---

Regarding the horn take a look at this thread...
http://www.berlingoforum.co.uk/showthrea...633&page=2

Brakes, check all is free in the cylinders and pivot points.

Wheel bearing, just replace it end of story, can you do it yourself ?

Halfords, use a local " normal " garage and develop a relationship / rapport for the future.

Geoff.

[mitumatu]

Taking the caps lock button off to type in lower case usually helps to pass the MOT as people can read your postings easier and then reply more often.... hint :whistle::whistle:

---

Regarding the horn take a look at this thread...
http://www.berlingoforum.co.uk/showthrea...633&page=2

Brakes, check all is free in the cylinders and pivot points.

Wheel bearing, just replace it end of story, can you do it yourself ?

Halfords, use a local " normal " garage and develop a relationship / rapport for the future.

Geoff.

Thanks Geoff on the horn, wheel bearing never done before but handy.
My sticky CAPS is repaired alsounny:

[geoff]

There you go progress already !

Have a read on the forum search for the bearing you will surely find something on it.

[mitumatu]

well i have to hold my hands up on the Exhaust as both sides of clip holding backbox and middle cat pipe rusted badly to the point that backbox came away with 1 inch of cat pipe.
Eurocarparts quoted £90 for middle section, found cat repair pipe £15

http://www.ebay.co.uk/itm/Citroen-Berlin...43bf0707d3

Already got new back silencer £30

---

There you go progress already !

Have a read on the forum search for the bearing you will surely find something on it.

:thumbsup:

[Rustscrat]

Bit of info below for the bearing change and rear brakes.
The bearings are usually in quite tight and a hydraulic press makes things easier.
Back brakes - could be the self adjuster mechanism is not working or the cylinder is seized up.
As for the horn, could be bad earth or connection as in other posts. :thumbsup:

  bear3.pdf (Size: 113.7 KB / Downloads: 7)

  mk2 rear brakes.pdf (Size: 206.94 KB / Downloads: 7)

[mitumatu]

Bit of info below for the bearing change and rear brakes.
The bearings are usually in quite tight and a hydraulic press makes things easier.
Back brakes - could be the self adjuster mechanism is not working or the cylinder is seized up.
As for the horn, could be bad earth or connection as in other posts. :thumbsup:

Thanks Rustscrat great info :thumbsup: