Thread Rating:
  • 1 Vote(s) - 5 Average
  • 1
  • 2
  • 3
  • 4
  • 5
help wheres the jack
#1
Hey guys can someone tell me where the jack is on a 11 reg mark 3 I have looked everywhere

thanks
Reply
#2
Might be the same, but on MK2 it's on the right hand side of the boot. The panel comes off and the jack is behind it...
[+] 1 user says Thank You to tucker for this post
Reply
#3
(11-02-2014, 02:45 PM)tucker Wrote:  Might be the same, but on MK2 it's on the right hand side of the boot. The panel comes off and the jack is behind it...

Which pannel mate have tugged at one on both sides neither Look like they open
Reply
#4
The right hand side as you look at the car from the back. There should be some plastic retaining clips that you turn and then you can remove the panel. You have to half turn them first if it's the same set up.
[+] 1 user says Thank You to tucker for this post
Reply
#5
(11-02-2014, 02:40 PM)steelviper Wrote:  Hey guys can someone tell me where the jack is on a 11 reg mark 3 I have looked everywhere

thanks

Look under either the passengers or drivers seat, there is a bit of carpet that lifts out and it will be under there. Mine is under the passengers seat.
You need to look from behind the seat.
--------------------------------------------------------------

2012 Iron Grey XTR 110 with lots of bits and bobs.
[+] 1 user says Thank You to Trevor for this post
Reply
#6
As Trevor says, but mine is under the drivers seat along with all the other tools
[+] 1 user says Thank You to ntm1275 for this post
Reply
#7
In that case the MK3 is obviously different Smile
Reply
#8
(11-02-2014, 05:33 PM)tucker Wrote:  In that case the MK3 is obviously different Smile

cheers guys

I have looked in all ur suggested places and still no jack or tools there's an empty compartment under the drivers seat I assume this is where the jack should be. Will have to ring the dealership and get them to order one in so much for the sixty point check they do eh.
Reply
#9
Yes, thats where it should be with a clip in cover. Make sure you get whole kit, scissor jack & plastic roll with wheel brace & long right angled torx driver for removing fog light if you have to change it.
[+] 2 users say Thank You to Opensauce for this post
Reply
#10
wow that's some amount of kit what's the plastic roll for ? Off to Peterbourgh on Thursday so will hope I don't need the jack Smile
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)
Welcome, Guest
You have to register before you can post on our site.


  

Password
  





Search Forums

(Advanced Search)

Latest Threads
Washers not working
Last Post:Redjoe100
Today 07:34 AM
» Replies: 7
» Views: 191
increase in a ratchet-typ...
Last Post:saskak
Today 12:36 AM
» Replies: 7
» Views: 121
DW8 engine tapping
Last Post:Hector Scorn
Today 12:30 AM
» Replies: 0
» Views: 16
Rear Wiper Motor
Last Post:madwelshman
Yesterday 10:42 PM
» Replies: 3
» Views: 116
Heater control unit/resis...
Last Post:mreid63
Yesterday 10:34 PM
» Replies: 5
» Views: 340
Loud beeping from radio u...
Last Post:Tonyash
Yesterday 10:13 PM
» Replies: 0
» Views: 26
Facial light replacement
Last Post:Mike
Yesterday 09:23 PM
» Replies: 11
» Views: 292
Reverse light switch prob...
Last Post:willpisme
Yesterday 08:09 PM
» Replies: 7
» Views: 162
Rear hub nut torque setti...
Last Post:geoff
Yesterday 07:31 PM
» Replies: 4
» Views: 97
Heyup
Last Post:polar
Yesterday 07:18 PM
» Replies: 9
» Views: 374

Locations of visitors to this page