Thread Rating:
  • 1 Vote(s) - 1 Average
  • 1
  • 2
  • 3
  • 4
  • 5
What screw is this?
I want to remove the lower silver section of my rear bumper to fit my towbar but the screws are an odd type

I've looked on the interweb and they could be tri-wing, y-star or something else

Does anybody know what screws these are and whether there is a way to remove them without having to buy the necessary screwdriver bit

[Image: screw.jpg]
I think that is a rivet & you will need to drill it out .
Yep, large pop rivets.
Large drill time
I am surprised that you need to remove that to fit your towbar. Ours (and others that I have seen) come out under the bumper.
Sorry, should have updated this thread

All OK now

I wanted to see if the silver plastic trim could be removed to give me a little bit more clearance when fitting before putting it back on after the towbar was fitted

In the end I did get the towbar on, but it was slightly more difficult because of the clearance issues

Forum Jump:

Users browsing this thread: 1 Guest(s)
Welcome, Guest
You have to register before you can post on our site.



Search Forums

(Advanced Search)

Latest Threads
Rear hub nut torque setti...
Last Post:El Berlingo
Today 01:14 PM
» Replies: 3
» Views: 43
Poor cold startup 1.9
Last Post:jj9
Today 09:42 AM
» Replies: 35
» Views: 843
peugeot charger
Last Post:Jed Clampit
Yesterday 11:28 PM
» Replies: 5
» Views: 164
Last Post:Jed Clampit
Yesterday 11:16 PM
» Replies: 2
» Views: 56
XTR heater control bulb r...
Last Post:VicG
Yesterday 10:57 PM
» Replies: 0
» Views: 40
Fuel consumption
Last Post:ron
Yesterday 09:41 PM
» Replies: 12
» Views: 307
Rear Wiper Motor
Last Post:minisandfords
Yesterday 08:48 PM
» Replies: 2
» Views: 96
Lower Ball Joint
Last Post:brodfather11
Yesterday 08:38 PM
» Replies: 2
» Views: 102
Bottom Ball joint
Last Post:Andyy
Yesterday 08:26 PM
» Replies: 6
» Views: 117
cutting out HDi 1.6 diese...
Last Post:Col
Yesterday 06:15 PM
» Replies: 18
» Views: 1479

Locations of visitors to this page