Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Manifold O2 sensor
Hi all,

After Receiving the upstream sensor yesterday I duly went to try and remove the old one using the 22mm sensor socket that I purchased and fell flat on my face. After removing the downstream sensor in the exhaust pipe I thought that the one in the manifold would be a breeze only to find that it will not budge and that the socket is rounding the edges.

I do have a normal 22mm long socket that I can use but was wondering if I cut the wires can I reattached them using electrical connectors if I fail to budge the sensor. Also is it possible to heat up the manifold using a blow torch or would this do damage to it and the Cat.

Cheers, Pitpan

Forum Jump:

Users browsing this thread: 1 Guest(s)
Welcome, Guest
You have to register before you can post on our site.



Search Forums

(Advanced Search)

Latest Threads
Front camber out of align...
Last Post:Col
Today 10:34 PM
» Replies: 8
» Views: 110
Last Post:Jane Rushby
Today 08:43 PM
» Replies: 3
» Views: 41
Eco activated but engine ...
Last Post:Lighty
Today 08:05 PM
» Replies: 17
» Views: 391
Roof bars for VTR?
Last Post:Jed Clampit
Today 07:57 PM
» Replies: 1
» Views: 23
M49 Budget DIY Camper con...
Last Post:Jed Clampit
Today 07:42 PM
» Replies: 21
» Views: 2283
Upgrading DAB radio recep...
Last Post:Multispacer
Today 07:39 PM
» Replies: 13
» Views: 2448
Berlingo VTR to ''XTR'' l...
Last Post:Multispacer
Today 07:17 PM
» Replies: 5
» Views: 206
Faulty Radio unit [or not...
Last Post:Multispacer
Today 07:13 PM
» Replies: 1
» Views: 224
Grinding noise when steer...
Last Post:tanto
Today 05:36 PM
» Replies: 1
» Views: 111
font fog light bulb chang...
Last Post:rdfb2
Today 05:11 PM
» Replies: 4
» Views: 107

Locations of visitors to this page